Hyundai Coupe Tiburon 2005 Owner's Manual page 297

1
CONTROLS AND EQUIPMENT
26
An ISOFIX-seat can only be installed if
it has vehicle-specific approval in ac-
cordance with the requirements of
ECE-R44. For your Hyundai, the
Hyundai ISOFIX GR1 / Hyundai Duo /
Römer ISOFIX GR1 and the Römer
Duo ISOFIX / Britax Duo ISOFIX is
approved according to the requirement
ECE-R44. This seat has been tested
extensively by Hyundai and is recom-
mended for your Hyundai.
ISOFIX Anchor
ISOFIX Anchor
Position Indicator
B230D02GK
gkfluk-1a.p65 26
On each side of the rear seat, between
the cushion and backrest, are located a
pair of ISOFIX anchorage points to-
gether with a top tether mounting lo-
cated in the luggage compartment. Dur-
ing the installation, the seat has to be
engaged at the anchorage-points in such
a way whereby you can hear it click
(check by pulling!) and has to be fixed
with the Top Tether-belt to the top tether
mounting located in the luggage-com-
partment. The installing and the use of
a child-seat has to be done according to
the installation manual, for the ISOFIX-
seat.
NOTE:
An ISOFIX-child-seat can only be
installed if the seat has a vehicle-
specific approval according to ECE-
R44. Before using the ISOFIX-child-
seat, which was bought for another
car, ask your Hyundai-dealer
whether this seat-type is approved
and recommended for your Hyundai.
11/21/2005, 2:56 PM
To secure the child restraint seat
HGK261
1. To engage the child restraint seat to
the ISOFIX anchor, insert the child
restraint seat latch into the ISOFIX
anchor. Listen for the audible "click"
sound.
2. Connect the tether strap hook to the
child restraint hook holder and tighten
to secure the seat. Refer to "Secur-
ing a Child Restraint System with the
Tether Anchorage System" on page
1-25.