Kantech tyco KT-1 Quick Start Manual

KT-1 One-Door Controller Quick Start Guide
Box contents
Before you install the controller, check that the product box contains
the following items:
• One KT-1 One-Door Controller
• One Accessories Kit
• Quick Start Guide
• Installation Guide
Technical support
For technical support contact details, refer to the Support section on
www.kantech.com.
Operating modes
Use the controller in one of the following three modes:
• Stand-alone mode: use as a stand-alone controller with direct
configuration. This does not require any software.
• EntraPass mode: use with EntraPass access control
management software to connect to additional doors and
controllers.
• Cloud mode: use with Cloudvue. This does not require any on-
premises application or server.
www.kantech.com
Powering the KT-1
2021-03-05
Power the KT-1 in one of the following ways:
• Power over Ethernet (PoE)
• Power over Ethernet plus (PoE+)
• Connect an external power supply to the 12 VDC input.
1 - Power the KT-1 as shown in the KT-1 One-Door Controller
Installation Guide.
2 - Connect the KT-1 using an Ethernet cable to the local area
network (LAN).
Configuring the KT-1 using a browser
Use the KT-Registration web page to configure the controller.
1 - Determine your connection to the KT-1 and choose the
appropriate network cable.
2 - On your computer or mobile device, open a web browser.
3 - In the address bar, type KT and the last six digits of the
controller's MAC address in the following format: KT-XX-YY-ZZ/.
Configuring stand-alone mode
To use the controller in stand-alone mode, you do not have to install
software. In stand-alone mode, you can perform all operations and
programming using a web browser.
Figure 1: KT-1 Registration page
Configuring stand-alone mode using the activate now
option
1 - On the KT-1 REGISTRATION page, click Standalone.
2 - On the Activate now tab, in the Customer information and
Installer information fields, enter the relevant information. See
Figure 2.
3 - Click Activate now.