Table of Contents
Advertisement
QUICK USER GUIDE
OPERATION OF A SINGLE SMART WAND™
After the inital programming, simply twist the TWIST HANDLE f of the
ungrouped SMART WAND™ to move your blind to the desired slat position
and release.
CONTROLLING A GROUP OF BLINDS
Once a group is created, you can twist any SMART WAND™ in the group and
release at the desired position. All other blinds in the group will automatically
move to the selected position.
OPERATION OF A SINGLE SMART WAND™ WITHIN A GROUP
Once a group has been set, twisting any SMART WAND™'s TWIST HANDLE
f will control the entire group. To operate a single SMART WAND within a
should hear a confirmation beep, signaling that the SMART WAND will now
group, quickly twist the TWIST HANDLE f , then quickly twist the TWIST
HANDLE f again in the opposite direction. After these two short twists, you
after the confirmation beep, proceed to twisting the TWIST HANDLE to the
control only that single blind. This mode will will time out without activity, so
position where you would like the single blind to remain.
24
LIGHT SENSOR AUTOMATION
The SMART WAND™ has an internal light sensor providing the capability to
automatically close your slats at night to provide full privacy in the room,
and open your slats in the morning to allow in natural light.
The LIGHT SENSOR SWITCH d allows the user to control the light sensor
and has three positions.
Top:
Sensor is turned off.
Middle: Sensor will open the slats around sunrise and close the
slats around sunset.
Bottom: Sensor will only close the blind around sunset.
TEMPERATURE SENSOR AUTOMATION
The SMART WAND™ contains an internal temperature sensor providing the
capability to automatically close your slats when the temperature near the
window is 82 F and open your slats when the temperature is 69 F. This
function is designed to help with energy savings and provide comfort in the
room.
The TEMPERATURE SENSOR SWITCH
temperature sensor and has three positions.
Top:
Sensor is turned off.
Middle: Sensor will open the slats at 69 F and
close the slats at 82 F.
Bottom: Sensor will only close the slats at 82 F.
e
allows the user to control the
25
Advertisement
Table of Contents
