Changing Batteries; Attaching A Smart Wand™ Extension Handle; Converting A Corded Tilt Blind - Current SMART WAND CP16E0060 User Manual And Installation Manual

CHANGING BATTERIES

Using two hands, carefully and slowly unscrew the BATTERY CAP g
[Fig. 23]. Batteries will naturally fall out of the battery tube.
Replace bad batteries with six (6)
new 1.5v Alkaline AA batteries.
Always replace all batteries.
NEVER mix old and new batteries.
Also, NEVER use damaged or
dropped batteries.
Replace the BATTERY CAP g .
short tune to confirm the batteries
The SMART WAND™ will play a
have been installed correctly.
ATTACHING A SMART WAND™ HANDLE EXTENSION
[Fig. 24]. Be sure not to remove Carefully remove the BATTERY
CAP g from the SMART WAND™
the batteries.
Attach EXTENSION HANDLE
K onto the end of the SMART 24.1].
WAND™. Screw into place [Fig.
Reattach BATTERY CAP g onto the end of the EXTENSION HANDLE
K . Screw into place.
20
Figure 23; Unscrew Battery Cap
Figure 23.1, Insert Batteries
Figure 24; Unscrew Battery Cap
Figure 24.1; Screw on Extension
CONVERTING A
HORIZONTAL
CORDED TILT BLIND
For further assistance with converting a corded tilt blind, please view
To install the SMART WAND™ to these types of blinds, you must first our online instructional videos.
Many venetian blinds use a cord to tilt the slats instead of a wand.
replace the corded tilt gear installed on your blind with the UNIVERSAL
TILT GEAR G included with your SMART WAND™ purchase.
the next steps on a table or other flat surface.
We suggest removing your blinds from the window and performing
First, remove the existing corded tilt gear from the blinds header. The
standard tilt gear assembly is shown in [Fig. 25].
Remove the tassels by either
cutting the cord or removing the
knots at the end of the cord [Fig.
26].
Typically, the tilt gear is removed
by sliding the rod out of the tilt
gear, slightly bending the header
and lifting the tilt gear out [Fig. 32].
Sometimes the rods are retained
in place through either a rod
pin, crimps or the end brackets.
While each manufacturer installs
you find it difficult to determine
these tilt gears differently, they
are relatively easy to remove. If
how to remove the corded tilt
gear, view our instructional video
located at
www.currentproductscorp.com\
support .
Figure 25; Full Assembly
Figure 26; Cut or Untie the knots
Figure 27; Remove Existing Gear by
Sliding Rod Out
21