Table of Contents
Advertisement
1. SETTING THE 1ST POSITION; FULL CLOSED- DOWN/
Twist the SMART WAND™ TWIST
HANDLE
f
[Fig. 17] to move the
slats of the blind to the FULL DOWN
OR LEFT position[Fig. 17.2 or 17.3]
then release the TWIST HANDLE
f ; be careful not to overtighten slats.
Press and hold the PROGRAMMING BUTTON
SINGLE BEEP (1) [Fig. 17.1].
Figure 17.2; Fully Down Blind Slats- Horizontal
Figure 17.3; Fully Right Blind Slats - Vertical
14
RIGHT
Figure 17; Twist
Figure 17.1;
Blinds to Full
Push and Hold
Closed
Programming
Button
b
until you hear a
2. SETTING THE 2ND POSITION; FULL OPEN
than the first phase of programming to
Twist the SMART WAND™ TWIST HANDLE
f
move slats of the shade to the FULL OPEN
position [Fig. 18.2 or 18.3], then release
the TWIST HANDLE f .
Figure 18; Twist
Figure 18.1;
Blinds to Full
Push and Hold
Open
Programming
Button
Press and hold the PROGRAMMING BUTTON
DOUBLE BEEP (2) [Fig. 18.1].
Figure 18.2; Fully Open Blind Slats- Horizontal
Figure 18.3; Fully Open Blind Slats- Vertical
[Fig. 18] in the OPPOSITE direction
b . You will hear a
15
Advertisement
Table of Contents
