Table of Contents
Advertisement
MAKING SENSE OF
THE SENSORS
SENSOR SWITCH POSITIONS
Off
Light and Temperature
Light Sensor closes at
Sensors are off.
sunset and opens at
Temperature sensor
opens the slats at 69
degrees and closes the
slats at 82 degrees.
SENSOR FEATURES
Once the LIGHT SENSOR makes an automatic movement, the slats will
not automatically open for another eight (8) hours.
Once the TEMPERATURE SENSOR makes an automatic movement, the
slats will not automatically open for another eight (8) hours.
The LIGHT SENSOR will prevent the temperature sensor from opening
your blinds at night to maintain your privacy.
A manual movement of a SMART WAND™ via the TWIST HANDLE f
or remote will deactivate the automatic features for three (3) hours.
When blinds are grouped, one sensor triggered movement will move
all blinds within that group.
18
Light Sensor Switch
Temperature Sensor Switch
Fully Automatic
Semi-Automatic
Light sensor only closes
the blind at sunset.
sunrise.
Temperature sensor
only closes the blinds at
82 degrees.
OPTIONAL STEPS
REMOVING A SMART WAND™ FROM A TWIST GROUP
Press and hold the PROGRAMMING BUTTON
WAND™ you wish to remove from the group until you hear a SINGLE
BEEP (1).
Repeat this step to remove additional SMART WAND™s from the
group.
ADDING A SMART WAND™ TO A TWIST GROUP
If you need to add an additional SMART WAND
ending programming, press and hold the PROGRAMMING BUTTON b
on the master SMART WAND™ until you hear a SINGLE BEEP (1), then
release. On any SMART WAND™ you wish to add to the group, press
and hold the PROGRAMMING BUTTON until you hear a SINGLE BEEP
(1), then release.
After all additional SMART WAND™s have been initialized, return
to the master to press and hold its PROGRAMMING BUTTON again
confirm the group has been successfully reformed.
until you hear a SINGLE BEEP (1). All blinds in that group will jog to
MASTER RESET YOUR SMART WAND
Master reset is performed to return a SMART WAND™ to its factory
default settings. All twist groups, paired remotes, and positional
settings will be removed from the memory of the SMART WAND™.
Press and hold the PROGRAMMING BUTTON (2) until you hear a
QUINTUPLE BEEP (5).
If you miss the signal for your desired set of beeps, listen for a
SEXTUPLE BEEP (6). This will reset the menu and prevent accidental
master resets.
b
on the SMART
™ to the group after
™
19
Advertisement
Table of Contents
