Table of Contents
Advertisement
Crestron Adagio™ AES
Configuration
Open Installer Tools
Operations Guide – DOC. 6456A
After making all hardware connections to the AES, the system must be configured
for operation.
Configuring the system is broken down into four processes:
•
Configure the AES for Operation
•
Configure Sources
•
Configure Rooms
•
Configure Preset Groups
Configure the AES for Operation
The AES must be configured for operation prior to configuring sources, rooms, or
groups. Use the Installer Tools to configure the AES for operation.
NOTE: If a custom program was created with Adagio Composer or SystemBuilder,
the following is not required.
•
Press and hold the ROOM and SOURCE buttons for 10 seconds to open
the Installer Tools menu.
Installer Tools Menu
Installer Tools
SOURCE
Select Tuner Format
ROOM
Configure Network
Set Number of Rooms
HOUSE
MENU
•
Scroll through the list of available options using the selection knob. The
selected option will be underlined. Available options are:
⇒
Select Tuner Format – Specifies the North American or European
tuning format when using a tuner card.
⇒
Configure Network – Configures the AES to communicate with
devices that are connected to the AES over Ethernet.
⇒
Set Number of Rooms – Sets the number of rooms to be controlled
by the AES.
⇒
Name Rooms – Allows custom naming of rooms controlled by the
AES.
⇒
Name Sources – Allows custom naming of audio sources
connected to the AES.
⇒
Identify Keypads – Registers APAD devices and C2N-DBF12
keypads that are connected to the system.
Entertainment System
BKLT
SCHED
DISPLAY
MORE
Entertainment System: Adagio AES • 23
Advertisement
Table of Contents
