Uploading And Upgrading; Establishing Communication - Crestron AES Operation Manual

Entertainment System

Uploading and Upgrading

Direct Serial Communication
USB Communication
58 • Entertainment System: Adagio AES
Crestron recommends using the latest programming software and that each device
contains the latest firmware to take advantage of the most recently released features.
However, before attempting to upload or upgrade, it is necessary to establish
communication.

Establishing Communication

Use Crestron Toolbox for communicating with the AES; refer to the Crestron
Toolbox help file for details. There are three methods of communication.
NOTE: Serial Communication or USB communication (see below) must be used
for initial setup of Ethernet parameters when the out-of-the-box functionality is not
used.
Direct Serial Communication
PC RUNNING
CRESTRON TOOLBOX
•
The COMPUTER port on the AES connects to the serial port on the PC via
the included serial cable (Crestron STCP-502PC or equivalent).
•
Use the Address Book in Crestron Toolbox to create an entry using the
expected serial communication protocol (RS232, auto-detect baud rate, no
parity, 8 data bits, 1 stop bit, XON/XOFF disabled, RTS/CTS enabled).
•
Display the AES' "System Info" window (click the
communications are confirmed when the device information is displayed.
NOTE: USB Communication or Serial communication (shown above) must be used
for initial setup of Ethernet parameters when the out-of-the-box functionality is not
used.
USB Communication
PC RUNNING
CRESTRON TOOLBOX
•
The USB port on the AES connects to the USB port on the PC via the
included USB cable.
•
Use the Address Book in Crestron Toolbox to create an entry using the
expected communication protocol (USB).
•
Display the AES' "System Info" window (click the
communications are confirmed when the device information is displayed.
Crestron Adagio™ AES
SERIAL VIA CRESTRON
CABLE STCP-502
OR EQUIVALENT
USB COMMUNICATIONS
VIA USB CABLE
Operations Guide – DOC. 6456A
AES
icon);
AES
icon);