Crestron AES Operation Manual page 32

Entertainment System
Configure Keypads
28 • Entertainment System: Adagio AES
Select Keypad Type
Identify Keypads
SOURCE
ROOM
HOUSE
MENU
APAD
•
Press the appropriate soft button to select the control device type (APAD or
keypad) for the first room controlled by the AES (Room Output 1). If there
is no control device for that room, press the soft button labeled None.
•
Follow the onscreen instructions for identifying the device. After
identifying the device, the AES will prompt for the next room's control
device.
NOTE: If a device is not identified within two minutes, the AES will
indicate that the keypad was not found. Try again by pressing the soft
button labeled Yes or cancel the process by selecting the soft button labeled
Abort.
•
Repeat the procedure until control devices for all of the specified rooms
(refer to page 25) have been identified.
This screen allows you to assign sources to the top six keys of a C2N-DBF12
keypad. The source assignment is applied to every C2N-DBF12 keypad that is
connected to the system. The functions of the bottom six keys cannot be changed
when using the out-of-the-box program.
•
Open Installer Tools as described on page 23, select Configure Keypads,
and press the ENTER button.
Select Button To Map
Select Button To Map
SOURCE
Btn1: S1 AM/FM
ROOM
Btn2: S1 XM
Btn3: Source 3
HOUSE
MENU
•
Turn the selection knob to select the button to be mapped and press the
ENTER button or the soft button labeled Edit. To cancel and return to the
Installer Tools menu, press MENU.
Crestron Adagio™ AES
Select keypad type
for Room 1
12But None
Edit
Operations Guide – DOC. 6456A
BKLT
SCHED
DISPLAY
MORE
BKLT
SCHED
DISPLAY
MORE