Table of Contents
Advertisement
2. ACCESSORIES
Below you can see contents of the box. First of all, check the list to make sure nothing is missing!
1.
Front cover (1x)
2.
Rear cover (1x)
3.
Screws (10x)
Tools needed: 2.5mm allen key
Installation time: 10 mins
3. INSTALLATION
Please follow the steps listed below to install the dome.
•
Remove the filament spool holder.
•
Remove the filament tube holder.
•
Remove the screws marked with an arrow on the top cover of the printer. (6x)
•
Place the rear cover to the printer. Please be sure, the cover sits properly on the printer's top cover.
FLOW / FLOW XL DOME
INSTALLATION MANUAL
www.craftbot.com
Advertisement
Table of Contents
Need help?
Do you have a question about the FLOWGENERATION FLOW and is the answer not in the manual?
Questions and answers