Line Restriction; System Privacy; Dialing Mode - Cortelco 2740 Instruction Manual

2.8.5.

Line restriction

It is possible to restrict any or all of the lines at a particular station. That station will not be able to
make any outgoing calls on the restricted lines, with the exception of the allowed numbers at that
station and calls to 911. The station can still receive incoming calls on these lines, take calls off hold,
and have full use of the intercom. This is normally used for phones which are placed in a public area.
To restrict one or more lines on a station:
a. Press MENU. The display will read Phone Setting
Press the DOWN ARROW repeatedly until Toll Restriction appears in the display.
b.
Press the soft key under ENTER. The display will read Enter Code:[all stations other than
c.
#01]
d. Enter the 4 digit toll restriction access code. A confirmation beep will sound and the display
will read "Set Restricted #"
e. Press the DOWN ARROW repeatedly, until "Line Restriction" appears in the display.
f. Press the soft key under ENTER.
Press the soft key under CHANGE to select between NORMAL (factory setting) and
g.
RESTRICTED.
h. Press the soft key under DOWN ARROW to see the current setting for Line 2, and repeat
steps e - g to change the settings for Lines 2-4.
i. Press MENU to exit.
2.9

System Privacy

Call privacy prevents stations from joining existing calls. Call privacy can be released during a call by
pressing the CONFERENCE button. The default setting for Call Privacy is ON.
Call Privacy is set at Station #01 for the entire system. This choice does not appear on any phone
except Station #01. Call privacy only applies to outside calls. Intercom calls always have call privacy.
To Change the Privacy Setting
At Station #01:
a. Press MENU. The display will read "Phone Setting"
Press the DOWN ARROW repeatedly until "Advanced Setting" appears in the display.
b.
Press the soft key under ENTER.
c.
d. Press DOWN ARROW repeatedly until "System Privacy" appears in the display.
e. Press the soft key under ENTER. The display will show the current Call Privacy setting.
f. Press the soft key under CHANGE to toggle the privacy setting between Y and N.
Press MENU to exit.
g.
Note: It may take 5 minutes or more for this change to be made in all phones in the system.
2.10

Dialing Mode

The 2740 can dial with either pulses or DTMF Tones. The mode is set at Station #01 for the entire
system. If any of the incoming telephone lines have Pulse service, Pulse Dialing must be selected. If all
the incoming lines have Tone Service, Tone Dialing should be selected. Tone Dialing is the default
setting. To set the dialing mode:
At Station #01:
Press MENU. The display will read "Phone Setting"
a.
13 2740 User Manual Version 1.11