Line Configuration/Type - Cortelco 2740 Instruction Manual

Line Configuration/Type

While Line 1 must be shared at all stations, Lines 2, 3 or 4 may be unconnected,
common, or may be connected to private lines.
Common Lines Shared
This is the factory setting for all lines. This setting assumes that the phone
number is connected to the same telephone line position at all stations.
Private
Use this setting at any telephone line position that is connected to a different
telephone number than the corresponding line at the other stations. For
example, you may connect your private telephone number to Line 4 at your
station instead of connecting your station to the common Line 4. In this
example, you would set Line 4 at your station as PRIVATE.
Unconnected
Use this setting at any telephone that may not have all lines physically connected.
How to Adjust the Line Configuration Type
• Press MENU. The display will read "Phone Setting."
• Press soft key under ENTER.
• Press the DOWN ARROW repeatedly until the display reads
"Line Connections."
• Press soft key under ENTER. The display will show the line connection
setting for Line 2.
• Press the soft key under CHANGE repeatedly, until the desired line
connection setting for Line 2 is displayed. The choices are:
- L2: Common (Factory Setting)
- L2: Private
- L2: Unconnected
• Press the soft key under NEXT to see the current setting for Line 3.
• Repeat above steps to change for the other lines.
• Press MENU to exit.
8