Message Waiting Lamp; Message Waiting Line Selection; Message Waiting Mode Selection; Caller Id On Call Waiting (Cidcw) Sensitivity - Cortelco 2740 Instruction Manual

i. Press the soft key under CHANGE
j. Enter the date as instructed in the display.
k. Press MENU to exit.
4.2

Message Waiting Lamp

The MSG lamp on the 2740 will flash when a voice mail signal is received. This feature requires either
voicemail from the telephone company or a voicemail signal from a PBX.
4.2.1

Message Waiting Line Selection

The 2740 will only respond to messages on one line. By default, this is set to Line 1. Follow the
instructions below to change this setting.
a. Press MENU
b. Press the soft key under ENTER
Press DOWN ARROW repeatedly until "Telco VMWI" appears in the display.
c.
d. Press the soft key under ENTER. The display will read "VMWI: LINE 1."
e. Press CHANGE repeatedly to select LINE 2, LINE 3, LINE 4, or OFF
4.2.2

Message Waiting Mode Selection

The 2740 can respond to either FSK or Stutter Dial Tone (SDT) message waiting signaling. To change
the mode, follow the steps below.
Press DOWN ARROW. The display will read "VMWI: FSK."
a.
b. Press the soft key under CHANGE to select SDT. This will activate the stutter dial tone
detector.
Press MENU to exit
c.
4.3

Caller ID on Call Waiting (CIDCW) Sensitivity

If the 2740 does not respond correctly to CIDCW signals, it may be necessary to adjust the sensitivity.
This adjustment is not normally needed since the 2740 default CIDCW sensitivity is correct for most
applications.
a. Press MENU,
b. Press the soft key under ENTER
c. Press DOWN ARROW repeatedly. "CIDCW: High Sens" or "CIDCW: Low Sens" appears
in the display
d. Press the soft key under CHANGE to change sensitivity
e. Press MENU to exit.
4.4

Hold Call Reminder

This feature will prevent calls from remaining on hold for a long time. By default, the 2740 will sound
an alert tone after a call remains on hold for 2 minutes. It will then sound an alert every 2 minutes
thereafter while the call remains on hold. This default reminder time can be changed to 30 seconds or 1
minute or the feature may be disabled.
Press MENU. The display will read "Phone Setting"
a.
b. Press the soft key under ENTER
c. Press Down Arrow repeatedly until "Hold Remind:" appears in the display
d. Press the soft key under CHANGE repeatedly until the desired held call reminder time is
displayed.
17 2740 User Manual Version 1.11