Cleaning Mode - Panasonic KV-S1037X Operating Manual

9.2.4 Cleaning Mode

Cleaning Mode can be used to help clean the conveyor rollers and the exit rollers. During Cleaning Mode,
the conveyor rollers and the exit rollers rotate a small amount every time the Start/Stop button (
the scanner is pressed. So you do not have to rotate the conveyor rollers and the exit rollers by using your
fingers in order to clean the entire surface of each roller.
Notice
•
Do not touch the rollers while they are rotating.
•
Use Cleaning Mode only to clean the conveyor rollers and exit rollers.
1.
Close the ADF door (page 31).
2.
Turn ON the unit's power (page 28).
3.
Enter Cleaning Mode.
•
When the scanner is connected via USB, use User Utility to enter Cleaning Mode.
•
When the scanner is connected via LAN, use Configuration Web to enter the Cleaning Mode (page
67).
4.
Open the ADF door (page 31).
5.
Clean the conveyor rollers ( ) and exit rollers ( ).
i.
Use the Roller Cleaning Paper (page 13) to wipe the rollers from one end to the other (in the
direction of the arrow) all the way around them, as shown in the illustration.
ii.
Press the Start/Stop button (
iii.
Repeat these steps until all surfaces of all rollers are cleaned.
2
6.
Exit Cleaning Mode after cleaning is completed.
) on the scanner to rotate the rollers a small amount.
1
9.2.4 Cleaning Mode
) on
81