Tannoy CVS 8 Quick Start Manual page 5

8
CVS Series
Installation Guide for SheetRock (Plasterboard) Ceilings
1. Mark the cut-out area on the ceiling by tracing around the template provided.
2. Cut out the hole in the ceiling using a circular saw or pad saw, then slide the C-ring into the ceiling,
aligning it over the cut-out hole.
3. Go to page 15 for wiring and set-up instructions then return to point 4 below.
4. Slide the speaker assembly through the hole and turn the screws to extend the mounting wings.
Tighten the screws until a firm grip is achieved.
If using a power driver, Tannoy recommends a torque setting of 1.5 Nm.
DO NOT OVERTIGHTEN!
5. Connect a Secondary Support Line to safety tab. Some construction codes require use of this secondary
support point, which should connect to a separate secure support point using a suitable support line.
Consult construction codes in your region.
6. Insert grille by pushing it onto the speaker.
Installation Instructions for Optional Plaster Ring
An optional plaster (mud) ring bracket is available from Tannoy. This bracket is designed to be pre-installed into newly constructed, non-suspended ceilings.
1. Nail or screw the plaster ring to the joists.
2. Lay the speaker wiring to where the speaker will be fitted and complete the plastering work on the ceiling.
3. Cut out the hole in the ceiling using a circular saw or pad saw.
4. Go to page 15 for instructions on wiring then return to point 5 below.
5. Slide the speaker assembly through the hole and turn the screws to extend the mounting wings.
Tighten the screws until a firm grip is achieved.
If using a power driver, Tannoy recommends a torque setting of 1.5 Nm.
DO NOT OVERTIGHTEN!
6. Connect a Secondary Support Line to safety tab. Some construction codes require use of this secondary
support point, which should connect to a separate secure support point using a suitable support line.
Consult construction codes in your region.
7. Insert grille by pushing it onto the speaker.
9
Quick Start Guide