Tannoy CVS 8 Quick Start Manual page 4

6
CVS Series
Accessories
Standard Accessories
CVS 8 Hole Cutout Size: 320 mm
CVS 6 Hole Cutout Size: 250 mm
CVS 4 / CVS 4 MICRO Hole Cutout Size: 180 mm
C-Ring
Grille
Paint Mask
Optional Accessories
Plaster (Mud)
Ring
Installation Guide for Suspended Ceilings
1. Remove the ceiling tile from its frame and place it on a flat surface. Mark the cut-out area on the ceiling
Tile bridge kit
tile by tracing around the template provided.
Note: A tile bridge kit
must always be used
when installing into
suspended ceiling tiles
Cut-out template
2. Cut out the hole in the ceiling tile using a circular saw or pad saw.
3. Place the C-ring and tile-bridge on top of the ceiling panel, aligning the C-ring over the hole, and screw the
C-ring to the tile bridge using the fixings provided.
4. Slide the speaker assembly through the hole and turn the screws on the front of the speaker to extend the
mounting wings. Tighten the screws until a firm grip is achieved.
If using a power driver, Tannoy recommends a torque setting of 1.5 Nm.
DO NOT OVERTIGHTEN!
5. Slide the tile panel back into the suspended ceiling. The tile bridge ends will catch over the railings,
supporting the weight of the speaker.
6. Connect a Secondary Support Line to safety tab. Some construction codes require use of this secondary
support point, which should connect to a separate secure support point using a suitable support line.
Consult construction codes in your region.
7
Quick Start Guide