INSTRUCTIONS - MASTERFIT IP
10. IP Control Settings
10. IP CONTROL SETTINGS
a. Access settings via set up tab
•
Access settings via set up tab
b. Setting of static IP address
•
Setting of static IP address
c. Mac address set up (If replacing on network)
d. Current IP operating parameters
•
Mac address set up (If replacing on
e. AMX Discoverable enable
network)
f.
Screen Technics Beacon
g. Simple control page
A, A+, B, B+, C, C+ Projection Screen
•
Current IP operating parameters
•
AMX Discoverable enable
•
Screen Technics Beacon
•
Simple control page
11. REGISTER SETTINGS
•
Access this menu by selecting System then Module Settings
•
Select MAF address or Module ID and select load
•
Change value and select update
•
This menu will enable changes of features within the module
•
127 registers in total
•
Screen shot below showing register page
Commonly Used
Registers
Register Number
65
Operation PIN
66
Programming PIN
67
Partial Pos 1 – Lo
68
Partial Pos 1 – Hi
69
Partial Pos 2 – Lo
70
Partial Pos 2 – Hi
4
Continued Over.../
Need help?
Do you have a question about the MASTERFIT IP and is the answer not in the manual?