Summary of Contents for Screen Technics ELECTRICINEMA
Page 1
ELECTRICINEMA Projection Screen Thank you for purchasing a Screen Technics Projection Screen, please ensure that you read the following instructions fully before to install this product. Wall Mounting Instructions Measure the wall where the screen is to be installed and mark with a pencil the desired height to top of screen case and also the centre of the screen.
Page 2
NB: Top of bracket equals top of screen canister. You may need to remove the bottom clip in order to screw brackets to wall, please ensure to replace them afterwards. Using two people install the screen by placing the screen canister into the bottom of the bracket clips and pivoting back the canister to slot the top pins into the T channels running along the top of the canister (you may have to remove any tape that is in the way).
Page 3
Holding screen in position tighten up Allen screw at each end and check that the top pins have hooked into the T section of the screen canister. Ceiling Mount Instructions Below is a photo showing a side view using the brackets for ceiling fixing, you would follow the instructions for the wall mounting system, with the only difference being the screen is mounted hard against the ceiling.
Page 4
Connect Control Module – Standard After the installation of the ElectriCinema Connect is completed, plug the screen into a standard power point and turn on. Point 1 - The screen comes with a standard 3 pin power plug which suitable for Australian and New Zealand GPO’s (general power outlet).
Page 5
Limit Setting for Connect ElectriCinema Screens The following instructions are for the adjustment of the limit switches that alter the upper and lower stop positions on "Connect" ElectriCinema Screens only Where are The Limit Switches? At the opposite end to the power cable (ie on the Right Hand Side).
Page 6
Anti-clockwise adjustment? - NO you will damage the micro switch if you turn it anti-clockwise while the screen is sitting on the limit. Never attempt this. You must back the screen away from the limit before adjustment. After adjustment you will need to run the screen up and down to pick up the new limit Will I void the product warranty if I damage the screen whilst making these adjustments? Yes.