Table of Contents
Advertisement
Notes:
1. Refer to the manual of your cell phone, tablet PC, computer or other Bluetooth enabled
devices for Bluetooth operation since it may vary from model to model.
2. If your Bluetooth enabled device does not support A2DP profile, it will not play the music
through the speaker, even if paired (linked).
3. Remember to turn off the JBS-215 when you have finished listening.
4. Don't forget to switch off the power of your external audio device as well.
PLEASE READ THIS IMPORTANT INFORMATION:
CD mechanisms used in devices like this are designed to fully read all commercial CDs. They
will also read self-compiled CD-R/CD-RW discs but it may take up to 10 seconds for playback
to start. If playback does not start, it is likely due to the quality of the CD-R/RW disc and/or
the compatibility of the CD compilation software. Manufacturer is not responsible for the
playback quality of CD-R/RW discs.
Do not attach a label or seal to either side of the CD-R/RW disc. It may cause a malfunction.
1.
Tap the
SOURCE
2. Press OPEN/CLOSE BUTTON to
CD/MP3 CD with its label side upward in the CD compartment and press
BUTTON to
close the CD door.
3.
The player will start reading TOC of the disc.
4.
The total number of tracks on the CD will appear on the LCD DISPLAY after a few
seconds. MP3 CD will take some more time.
5.
Tap the PLAY/PAUSE
6.
Adjust the VOLUME - / VOLUME+ to obtain the desired sound.
7.
To suspend playing, tap the PLAY/PAUSE
the PLAY/PAUSE
8.
You can choose to play your favorite track directly by
LCD Display will indicate the correct track number selected.
9. To locate a particular section within a track, press and hold the
the section is found.
10.
To repeat a particular track, tap the PLAY MODE BUTTON repeatedly until the REP 1
indicator lights on the LCD DISPLAY.
11.
To repeat the entire CD, tap the PLAY MODE BUTTON repeatedly until the REP ALL
indicator lights on the LCD DISPLAY.
12.
To repeat the random track, tap the PLAY MODE BUTTON repeatedly until the RAND
indicator lights on the LCD DISPLAY.
13.
To stop playing, tap the STOP
14. Press
/SOURCE
PROGRAM OPERATION
This function allows the tracks to be played in a programmed sequence. Programs can be set
in STOP mode.
1. Tap the
MEM/PROG BUTTON
Number "P01" will show on the LCD DISPLAY.
2. Tap the
/
The track number 01 will blink on the LCD DISPLAY to prompt for input.
3. Tap the
MEM/PROG
change to P02.
CD OPERATION
BUTTON to CD position.
BUTTON
BUTTON
again.
BUTTON.
BUTTON
to OFF position to turn off the unit.
once. The PROG Indicator will light and program Channel
dial to select the track to be programmed.
BUTTON
again to store selection. The Program Channel No. will
open the CD door and carefully place an audio
to start to play.
BUTTON
10
OPEN/CLOSE
again. To resume playing, tap
tap the
/
BUTTON. The
/
BUTTON until
Advertisement
Table of Contents
