Usb Charging; Resetting The Unit; Care And Maintenance - Jensen JBS-215 User Manual

CONNECTING A USB CORD (NOT INCLUDED) FOR CHARGING YOUR CELL PHONE (DC
5V 1 A)
1. Plug the standard end of the USB cable (not included) into the USB CHARGING PORT
located on the back of the unit. Plug the other end of the cable into the device you wish to
charge.
2. Observe the battery charge indicator on your device to make sure the charging process
starts normally.
3. Unplug the cable when your device is fully charged.
WARNING!
 The USB port located on the back of the unit is designed for a smart phone or portable
device battery charging only and does not support data transfer or connection to a
computer.
 Don't connect the USB port of the unit to another USB charger. It may damage both units
and void the warranty.
In case of malfunction due to electrostatic discharge, reset the unit by unplug
the back of the unit.
1. Clean your unit with a damp (never wet) cloth. Solvent or detergent should never be used.
2. Avoid leaving your unit in direct sunlight or in hot, humid or dusty places.
3. Keep your unit away from heating appliances and sources of electrical noise such as
fluorescent lamps or motors.
4. If drop-outs or interruptions occur in the music during CD play,
or if the CD fails to play at all, its bottom surface may require
cleaning. Before playing, wipe the disc from the center
outwards with a good soft cleaning cloth.

USB CHARGING

RESETTING THE UNIT

Wait for 2-3 minutes before plug the DC Jack on the back of the unit.

CARE AND MAINTENANCE

12
the DC Jack on