Table of Contents
Advertisement
3 FCC Statement
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
93
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the SAX1V1K and is the answer not in the manual?
Questions and answers
Can the router be configured to add 2.4 Ghz output while retaining current 5 Ghz output?
Can router be configured for both 2.4 Ghz and 5Ghz Operation at same time?
Yes, the Askey SAX1V1K router supports dual-band wireless operation with both 2.4 GHz and 5 GHz frequencies, allowing for simultaneous operation on both bands.
This answer is automatically generated
can wifi be turned off?
Yes, the Wi-Fi can be turned off on the Askey SAX1V1K by selecting “No” in the "Enable Radio" setting.
This answer is automatically generated