This pump is for use with permanently installed pools and may also be used with hot tubs and • Tighten Sta-Rite trap lids to 30 ft. lbs. (4.1 kg-m) torque spas if so marked. Do not use with storable pools. A for testing.
P P o o r r t t t t h h r r e e a a d d s s : : Internal - 2" NPT for direct connection to pipe. External - 3" Piping: Buttress. Fits Sta-Rite 38405 - 4094 Union Collar for quick Use at least 1-1/2" (38mm) pipe (use 2"(51mm) pipe if disconnect pipe connection.
Fittings: ELECTRICAL Fittings restrict flow; for best efficiency use fewest possi- Ground motor before ble fittings. connecting to electrical Avoid fittings which could cause an air trap in suction power supply. Failure to ground motor can cause se- piping. vere or fatal electrical shock Pool and spa drains must conform to International hazard.
Page 5
Use Ground Fault Circuit Interrupter (GFCI) as master on- Exactly match supply voltage to motor nameplate off switch; it will sense a short circuit to ground and dis- voltage. Incorrect voltage can cause fire or seri- connect power before it becomes dangerous to pool ously damage motor and voids warranty.
To Wire a Two-Speed Motor OPERA TION Wire the pump as shown in the diagram. N N O O T T I I C C E E : : NEVER run pump dry. Running pump dry may damage seals, causing leakage and flooding. Fill pump Ground (Green) with water before starting motor.
Drain all water from pump and piping when expecting PUMP SERVICE freezing temperatures or when storing pump for a long Pump should only be serviced time (see instructions below). by qualified personnel. Keep motor dry and covered during storage. Be sure to prime pump (Pg. 6) To avoid condensation/corrosion problems, d d o o n n o o t t cover before starting.
Page 8
7. Remove four screws holding seal plate to motor. 2. If ceramic seat will not locate properly, remove it, place f f a a c c e e u u p p on bench and reclean cavity. Ceramic 8. Place seal plate face down on flat surface and tap out seat should now locate.
TROUBLESHOOTING E E l l e e c c t t r r i i c c a a l l : : 1. Pump may be running too GUIDE slowly; check voltage at Read and understand safety and operating instruc- motor terminals and at tions in this manual before doing any work on meter while pump is run-...
For quick disconnect pipe connec- tions, purchase separately Part No. 77703-0105 (2" Slip and 1-1/2" Slip Union Kit) . Kit Includes: 2 #38405-4094 Union Collars 2 #35505-1244 O-Ring 1 #38405-4095 2" Slip Adapter 1 #38405-4096 1-1/2" Slip Adapter REPAIR PARTS LIST 1 through 2-1/2 HP Spa Pumps Part Part...
• Complete a warranty registration at www.staritepool.com by clicking on “Register Products” and selecting Sta-Rite Pool OR • Complete bottom portion completely and mail within 10 days of installation to Sta-Rite, Attn.: Pool Warranty Dept., 293 Wright St., Delavan , WI 53115 Warranty Registration Card ■...