Connector
USB(VA)
Headphone
Before repairing connectors, follow these steps:
Prepare the monitor for disassembly. See Preparation for disassembly on page 13.
▲
DP connector CN301/CN401
Repair the DP connector:
1) Use a hot air gun to melt the solder on the pins. Pin solder with soldering iron and absorber. You can gently
push down with the soldering iron once everything is molten to move the CN301/CN401 out of the through
holes.
20
Connector location showing of main board
Location
P103, P104
CN102
Connector location showing of USB side board