Dp Connector Repair- J14, J15 - HP Z27 G2 Series Maintenance And Service Manual

DP Connector repair- J14, J15

1) Use a soldering iron and a de-soldering pump to remove as much solder as possible
from one of the pin.
2) Use a hot air gun to melt the solder on the pins
3) Lift connector from the PCB
4) Place new component on the location, and must check it can match PCB footprint
5) Soldering the new component by solder iron
6) Tear off the yellow tape on the DP connector, so that it can contact to the gasket, EMI
will be effective.
7) Please must stick a gasket on the Shielding.
24