Assembly Preparation; Assembly Instructions; Mounting The Grease Exhaust Tube; Attaching The Heat Shield - Pit Boss PBV3PU1 Assembly And Operation Manual

Parts are located throughout the shipping carton, including underneath the grill. Inspect the grill, parts, and hardware blister pack
after removing from the protective shipping carton. Discard all packaging materials from inside and outside of the grill before
assembly, then review and inspect all parts by referencing the parts list. If any part is missing or damaged, do not attempt to
assemble. Shipping damage is not covered under warranty. Contact your dealer or Pit Boss® Customer Service for parts: Monday
through Sunday, 4am - 8pm PST (EN/FR/ES).
service@pitboss-grills.com | Toll-Free: 1-877-303-3134 | Toll-Free Fax: 1-877-303-3135
IMPORTANT: To ease installation, using two people is helpful (but not necessary) when assembling this unit.
IMPORTANT: It is advised to read each step entirely before starting assembly on instructions. Do not tighten screws completely
until all screws for that step have been installed, or unless otherwise mentioned.

1. MOUNTING THE GREASE EXHAUST TUBE

Parts Required:
Grease Exhaust Tube (#18)
1 x
2 x Screw ( #E)
Installation:
• Place a piece of cardboard on the floor to prevent scratching the unit and
parts during assembly. First, lift the main cabinet door off the hinges, and
place aside. Note illustration 1A
• Next, flip the main cabinet, bottom side pointed upward, on the cardboard.
• Mount the grease exhaust tube to the underside of the main cabinet using
two screws. Note illustration 1B.
IMPORTANT: Ensure there is a good seal to the main cabinet, as grease
will come from the main cabinet, flow through the exhaust tube, and
exit into the grease tray.

2. ATTACHING THE HEAT SHIELD

Parts Required:
1 x Heat Shield (#19)
2 x Screw ( #D)
Installation:
• Position the heat shield between the control board and the grease exhaust
tube. Secure using a screw on each side.
IMPORTANT: If this part is not installed correctly, the heat and/or splatter
from the grease exhaust tube may cause damage to the control board.
Grease damage to the rear of control board is not covered by warranty.

ASSEMBLY PREPARATION

Tools required for assembly: screwdriver and level. Tools not included.

ASSEMBLY INSTRUCTIONS

1A
7
1B
E
18
2
19
D
7