Programming The Cm707; Disabling / Enabling Time Periods - Honeywell Home CM707 User Manual

PROGRAMMING THE CM707

until the 'flashing' day indicator is under the
required day, then accept it by pressing the
green button. Note: Once the target
day is confirmed it becomes the day that is
copied if the COPY DAY button is pressed
again.
OR
ii) Press the DAY button to move the day
indicator to Tuesday (Day 2). The program
for that day can then be adjusted by
following steps b to e. Programs for the
remaining days can be set in the same way,
using the DAY button to move to the next
day.
To exit the programming mode select the
desired operating mode by pressing the
AUTO, MAN or OFF buttons. Note: To run the
adjusted program select the AUTO mode.

Disabling / Enabling Time Periods

The thermostat has 6 periods each day that
can be programmed, but you may not need
all of these switch points for your heating
requirements. Therefore, any period from 2
to 6 can be removed from (or returned to) the
heating program profile.
To disable or enable time periods:
a. To disable unwanted periods go to the
desired period (
2
PROGRAM or buttons to navigate,
ensure the correct period is highlighted with
the flashing square symbol. Press and hold
the button for at least 2 seconds and the
display will indicate the period has been
removed from the program.
b. To enable periods again follow the same
procedure as above, navigating to the
already disabled period. To enable this
period again press and hold the
for at least 2 seconds.
to ) using the
6
button
'Efficient Daily Use'
ENG
29