Table of Contents
Advertisement
Available languages
Available languages
ENG
'Efficient Daily Use'
The Built-in Heating Program
The built-in heating program has 6 temperature level changes per day that can be set between
3.00am and 2.50am the following day - allowing you to maintain the evening temperature after
midnight. Each temperature level can be set between 5°C and 35°C, and adjusted in 0.5°C
increments. The factory default program for heating is as follows.
Monday to Friday (Day
1 to 5)
Saturday & Sunday
(Day 6 & 7)
Reviewing the Heating Program
To review or edit the heating program use the PROGRAM
individual programming periods for that day. Use the DAY button to step through each day of the week,
so the complete 7 day heating program can be reviewed or edited.
Modifying the Heating Program
To change the heating program:
a. Press either of the PROGRAM
buttons to enter the programming mode.
The time / temperature settings for period
on Monday (Day 1) will be flashing as
1
shown. The active period is highlighted by a
flashing square around the numbers at the
bottom of the screen and the selected day
is shown with the day indicator.
1
2
3
4
1 2 3 4 5 6
b. To adjust the period start time use the
or
buttons, the 'OK?' indicator will be
displayed to confirm the change. Holding
the button down will change the time
quickly.
Note: If you are pressing the
buttons and the display flashes the next
period, it means the next period will be
pushed forward.
28
Period
1
Time
6:30
Temperature
21°C
Period
1
Time
8:00
Temperature
21°C
or
5
6
7
or
PROGRAMMING THE CM707
2
3
4
8:00
12:00
14:00
18°C
21°C
18°C
2
3
4
10:00
12:00
14:00
21°C
21°C
21°C
or
buttons to navigate between the 6
c. Once the required time is reached press the
green
button to confirm.
Note: If the original time setting did not
require adjustment press the green
button to move to step 'd'.
d. The temperature setting for period on
Monday (Day 1) will now be flashing. To
adjust this press the
confirm the setting again by pressing the
green
button.
e. The next time and temperature period will
now be active. Adjust this by repeating
steps b - d above until all 6 periods are set
for Monday or press the AUTO button to run
the program as set, at any time.
You now have a choice of how to set the
program for the next day:
f. i) Press the COPY DAY button to copy
Monday's program into Tuesday. The
display will go blank apart from the 'non
flashing' day indicator, which indicates the
day copied and the 'flashing' target day to
copy the program to. To accept this day
press the green
different target day press the DAY button
5
6
18:00
22:30
21°C
16°C
5
6
18:00
23:00
21°C
16°C
1
or
buttons and
button. To select a
Advertisement
Table of Contents
