Viking E-10-IP Product Manual page 7

D. Replacement IP Board Kit (Model E-1600-53-IP)
This is a board (PCB) only kit. NO chassis is included. This kit can be used to replace a damaged "IP' board in the field.
The kit comes in standard and EWP versions. The optional EWP version features foam rubber gaskets and boots,
sealed connections, gel-filled butt connectors, as well as urethane or thermal plastic potted circuit boards, see DOD
859 for more information. The kit can also be used to convert 2008 or newer Viking E-30 analog phones to a VoIP
version. A special connector and microphone assembly is required to convert 2007 and older Viking E-30 analog phones.
Contact Viking Technical Support if attempting to install this kit in these older phones.
(2) 0.156
diameter
type 2
mounting
holes
On-Board 2 Amp Relay
Output Contacts Connector
Connect to doorstrike,
mag lock, gate controller, etc.
Gray (N.C.)
Blue (COM)
Yellow (N.O.)
** Note: These two red wires are only used on units with an Info button. When
installing on a single button unit, cut off these two red wires and discard.
Note: When European CE compliance is required, mount in a metal enclosure.
How to Replace Analog E-10A-EWP or E-30-EWP Circuit Boards:
Step 1. Cut wires from J1 (10 pin connector) and J2 (2 pin connector).
Step 2. Remove the two #6 phillips screws fastening the circuit board.
Step 3. Cut off any stripped wire ends from the replacement cable.
Using the supplied gel-filled butt connectors, connect corresponding wires from replacement cable to the previously cut
Step 4. wires from the LED (E-30-EWP only), Call switch, Speaker and Microphone. See FIGURE 1 above for wire color and
polarity.
Note: The gel-filled (water-tight) butt connectors are designed for insulation displacement on 19-26 gauge wire with a
maximum insulation of 0.082 inches. Cut off stripped wire ends before terminating.
3.50 (3.58 EWP)
3.20
3 1 10 1
Connector and Wires
from Existing Standard
(non EWP) E-30 Analog
Entry Phone
E-1600-53-IP Board Specifications
0.15 (0.19 EWP)
Shipping Weight: 1 lb (.45 kgl)
Connections: (1) RJ45 10/100 Base-T, (3)
optional gel-filled butt connectors, (10)
additional gel-filled butt connectors included
2.0
with EWP version only.
(2.04
EWP)
2.63
1.5
(2.71
EWP)
0.63
(0.67
EWP
Black
Red
Black
Black
- OR -
White
White
Black
Red
7
FIGURE 1
Replacement Cable Assembly
(included) with E-1600-53-IPEWP
Replacement connectors, wires
and butt connectors for use when
replacing EWP circuit boards.
- Black
LED
+ Red
Black
Call Switch
Black
Red**
Info Switch
Red**
Yellow
Speaker
Yellow
- Black
Mic
+ Red
(not used)