Viking E-10-IP Product Manual page 14

Note: A majority of the features below can also be Touch Tone (In-Band DTMF) programmed. See DOD 949.
7. Speed Dial Phone Numbers
Note: Up to 79 digits can be stored in each of the 5 speed dial phone number positions.
The number programmed in the first location under "Speed Dial Numbers" is the telephone or extension number that is
dialed when the call button is pressed. Additional numbers (if programmed) will be dialed when there is no answer and
the Dial Next No. on Ring No Answer feature is enabled. The Entry Phone will also detect busy and move on (Dial
Next Number on Busy Enabled). The Entry Phone will cycle through the programmed Speed Dial numbers until
answered.
8. Security Code
The security code allows the user/installer to program the Entry Phone. It is recommended that the factory set security
code be changed. Factory Setting: 845464
Note: The security code must be 6 digits and cannot include a Q or a #.
9. ID Number:
The ID Number (1 - 6 digits) is used by emergency personnel to identify the location of the caller and is given out when
the receiving party presses a Q
field blank. Factory Setting: 987654
10. Access Code
The Access Code is used for remotely operating the relay (Doorstrike, Mag-Lock, etc) by calling into the unit. This code
provides basic security and only allows operation of the relays and not the ability to change any of the programming
parameters. Once entered, any of the "Remote Access Operation Commands" can be used. The code can be 1 - 6
digits in length and cannot contain a "Q" or "#" or match the numbers used for the security code. Simply call the Entry
Phone (set to auto-answer/auto-answer secure), the unit will automatically answer the line and output one beep. You
then enter the programmed 1 - 6 digit access code, 2 beeps should be heard. You can now enter any "Remote Access
Operation Commands" (see page 21). This code will also enable audio to/from the speaker and the caller. The access
code can be cleard (by leaving the field blank) if this additional level of security is not required. Factory Setting: 123456
This ID number is transmitted as In-Band DTMF. This can be cleared out by leaving the
.
14