Advertisement
Procedure 32
Back Panel Removal:
Provides access to all electrical and
mechanical components at the
back of the stove.
Step 1: Disconnect power supply
to range.
Step 2: Pull unit away from wall
(units are equipped with 2" diameter
teflon gliders). Please ensure stove
is attached to a flex line to allow the
unit to be pulled out for service)
Step 3: Remove outer row of
screws securing the back panel to
range (start with bottom screws and
work towards the screws near the
top).
Step 4: When removing last screw,
hold on to panel to prevent
dropping.
- Panel Removal/Access
Step 5: Gently pull panel back and
disconnect red and black wires to
cooling fan (do not forget to re-
attach these at the end of any
service work).
Relay Board Panel Removal
Step 6: Relay board can be
accessed by removing small
access cover at the lower left
corner of the range.
Step 7: Disconnect power supply
to range.
Step 8: Remove outer row of self
tapping screws
51
Section 5-3
Step 9: gently pull out and drop
access cover down.
MLSM2003-01-03
Hide quick links:
Advertisement
