Troubleshooting - Sharp IG-GC2EU Operation Manual

TROUBLESHOOTING

PROBLEM
The Plasmacluster Ion
Generator does not work.
The operation does not stop
although the engine of vehicle
is switched OFF.
The product does not operate
in conjunction with engine.
The Unit Replacing Light
flashes rapidly and the
operation is stopped.
The Operation Lights "LOW "
and "MED" (blue) and
"TURBO" (purple) flash at the
same time and the operation
is stopped.
A discontinuous noise is
heard.
A clicking or ticking sound
comes from the unit.
The operation Lights in blue
or purple flash then the unit
stops operating.
Other indication
WHAT TO DO
• Is the Car Adapter connected properly? Ensure it
is connected correctly. (See E-5)
• If the main unit is operating even though the key
of the vehicle is pulled out or the engine switch is
turned OFF, pull out the car adapter out to prevent
having a dead battery. (See E-7)
• In a vehicle where the power is supplied to the
accessory socket even if the engine of vehicle is
switched OFF, the engine interlocking function
cannot be used.
• The main unit is past its usage period. Replace it
with a new Plasmacluster Ion Generating Unit.
(See E-11)
• If the unit replacement period is exceeded, the
Unit Replacing Light (red) flashes rapidly and the
operation is stopped.
• The Plasmacluster Ions are not generated.
Perform maintenance of the electrode section.
(See E-9)
• If the Light fl ashes repeatedly, contact the store
of purchase or SHARP authorized service centre.
• Is the Plasmacluster Ion Generating Unit installed
correctly? Pull out the unit and insert it again and
then press the operation button. (See E-11)
• Clicking or ticking sound may be audible when the
unit is generating ions. You may feel the sound
becomes louder or softer depending on use
environment or operation mode, however, the
effect of Plasmacluster Ion is not changed.
• Dust may block the filter. Clean the filter. (See
E-8)
• Please remove the car adapter and re-insert it,
then press the operation button again.
• If this happens repeatedly, contact the store of
purchase or SHARP authorized service centre.
• Failure
Unplug and contact the store of purchase or
SHARP authorized service centre.
E-12