Electrical Connection - RIB KIT IDRO C 27/1B Manual

G
B
3.5.2 Checking the motion
!
Warning
• When the mounting is completed, neutralize the hydraulic lock (if present in the operators)
by turning the correct key through 180° counter-clockwise, and move the gate-leaves
manually to check on the smoothness of the movement; this should be done very slowly,
otherwise the operators will take in air and, consequently, will have to be bled.
• Open and close the gate leaf to check that the operator can move freely without rubbing
and without going against either the gate leaf or the gate post.
• After making the checks, reset the hydraulic lock by turning the release key fully in a
clockwise direction.

3.5.3 Electrical connection

Make the electrical connection according to the wiring diagram (D1) - see paragraph "System
electrical connection".
Connect the supplied capacitor (B4 pos. 12) to the electric control unit according to the wiring
diagram of the unit itself.
3.5.4 Fitting the protection casing and removing the bleed screw
Fit the protective casing (E1 pos. 1) to rod and insert into the operator.
Hold the casing bottom (E2 pos. 2) in position with a cross-head screwdriver (E2 pos. 3).
Fit the push-on cover (E3 pos. 2) on to the protective casing (E3 pos.1).
Tighten the fixing screw of the protective casing (E4 pos.1).
On completion of the assembly, remove the bleed screw (E5 pos. 4) using a CH7 hexagonal wrench.
E1
E2
E3
1
2
36
E4
1