Withings BPM Connect Instruction Manual page 25

RF Statement
Medical Electrical Equipment needs special precautions
regarding EMC and needs to be installed and put into
service according to the EMC information provided in
the following. | Interference may occur in the vicinity of
equipment marked with the following symbol: | Portable
and mobile RF communication equipment (e.g. cell phones)
can affect Medical Electrical Equipment. | The use of
accessories and cables other than those specified may result
in increased emissions or decreased immunity | The device
uses RF energy only for its internal function. Therefore, its
RF emissions are very low and are not likely to cause any
interference in nearby electronic equipment | The device
is suitable for use in all establishments, including domestic
establishments and those directly connected to the public
low voltage power supply network that supplies buildings
used for domestic purposes | Portable and mobile RF
communications equipment should be used no closer to any
part of the device, including cables, than the recommended
separation distance calculated from the equation applicable
to the frequency of the transmitter | The device is intended
for use in an electromagnetic environment in which radiated
RF disturbances are controlled. Any other accessories,
transducers and cables may result in increased emissions
or decreased immunity and EMC performance. | The device
should not be used adjacent to or stacked with other
equipment and that if adjacent or stacked use is necessary,
which should be observed to verify normal operation in
the configuration in which it will be used. Medical Electrical
Equipment needs special precautions regarding EMC and
needs to be installed and put into service according to the
EMC information provided in the following. Portable and
mobile RF communication equipment (e.g. cell phones) can
affect Medical Electrical Equipment. The use of accessories
and cables other than those specified may result in increased
emissions or decreased immunity of the unit.
Guidance and manufacturer's declaration-electromagnetic emissions
This Wi-Fi Smart Blood Pressure Monitor is intended for use in the electromagnetic
environment specified below. The customer or the user of the Wi-Fi Smart Blood Pressure
Monitor should ensure that it is used in such an environment.
Emissions test Compliance
CE emissions
Group 1
CISPR11
RE emissions
Class B
CISPR11
Harmonic emissions
Not applicable
IEC 61000-3-2
Voltage fluctuations/
Flicker emissions Not applicable
IEC 61000-3-3
Electromagnetic environment — guidance
The Wi-Fi Smart Blood Pressure Monitor uses RF
energy only for its internal function. Therefore,
its RF emissions are very low and are not likely
to cause any interference in nearby electronic
equipment.
This Wi-Fi Smart Blood Pressure Monitor is suitable
for use in all establishments, including domestic
establishments and those directly connected to
the public low-voltage power supply network that
supplies buildings used for domestic purposes.
25