Timer Mode; Table Of Zones - Clarion SR1000 Installation Manual

timer mode

By pressing the remote
vehicle and run for the set duration. The remote start can be shut off by the remote by pressing the
remote start button
becomes active the timer mode will cancel.
1. Press Timer mode buttons.
2. The vehicle will confirm with 4 parking light flashes.
3. A 1-second delay will start.
4. The system will start the car and will run for the specified duration, unless shut down by the
remote start button
timer mode.
5. The system will start every 3 hours until canceled by the brake, hood, or neutral safety shut-down
wires.
To exit timer mode, turn the ignition switch on any time the engine is not running. The parking lights
will flash 4 times, indicating timer mode has been exited.
5. The system will start every 3 hours until canceled by the brake, hood, or neutral safety shut-down
wires.

table of zones

When using the Diagnostic functions, use the Table of Zones to see which input has triggered the sys-
tem. It is also helpful in deciding which input to use when connecting optional sensors and switches.
ZONE NO. TRIGGER TYPE
1 Multiplexed Input
2 Multiplexed Shock Sensor Input Mux BLUE wire.
3 Door Trigger
4 Multiplexed Shock Sensor
5 Ignition
6 Hood Brake Trigger
N N O O T T E E : : The warning response does not report on the LED.
and buttons the parking lights will flash 4 times and then start the
and remain in timer mode, but if any other shut down zones or the ignition
. If shut down with the remote start button
INPUT DESCRIPTION
BLUE (H1/6)
GREEN (H1/5) and VIOLET (H1/7).
Mux GREEN wire
Yellow ribbon harness wire
GRAY on the 5-pin shutdown harness.
the system will remain in