Timer Mode - Clarion SR9000 Installation Manual

To turn the rear defogger output ON:
1. Press & release the
2. The parking lights will flash 3-times.
3. The rear defogger output will once again activate when the vehicle is remote started.
NOTE: If the remote start is On the lights will turn off then flash 3-times before returning to their
normal output and the defogger output will activate as programmed.

timer mode

This unit can be programmed to start and run the engine every three hours, for a maximum of six cycles. The
engine will run for the programmed run time and then shut down. After three hours, the system will restart the engine.
IMPORTANT! Timer Mode should be used only in open areas. Never start and run the vehicle in an
enclosed space such as a garage or carport.
To enter or exit timer mode with the transmitter:
The same procedure may be used to enter or exit Timer Mode using the remote transmitter:
1. Remote start the vehicle by pressing
2. The lights will flash 4-times.
3. After 1-second the car will start and the timer mode will run for the specified time period.
The system is in Timer Mode. The engine may be allowed to run for its programmed run time, or the transmitter
can be used to shut down the engine. Either way, the remote start system will restart the engine again in three
hours. Timer Mode is exited automatically after the sixth run cycle.
To enter or exit timer mode manually:
1. Make sure the remote start system is not operating the engine.
2. Turn the ignition on.
Timer Mode will be exited and the parking lights will flash four times.
52
and and buttons of the remote control.
and simultaneously.
© 2007 Directed Electronics—all rights reserved