Table of Contents
Advertisement
Silent Arming / Disarming
Each Remote Transmitter can be individually set to always Arm and Disarm the system with or without chirp confirmation at
the time they are programmed into the system (See Adding a New Transmitter into the System Page 9).
To temporarily cancel the Arming and Disarming confirmation chirps, you can Arm or Disarm the system by pressing Button 3.
Note: The confirmation chirps will only be cancelled if the system status is normal. The chirp indications for Tamper Alert
and the open zone warning will not be cancelled when the system is Armed or Disarmed silently.
Arming Mode Selection
Your system can be set in one of the following Arming Modes:
• Passive (automatic) Arming with chirp confirmation
• Active Arming (by Remote Only)
• Passive (automatic) Arming without chirp confirmation
To set the Arming Mode:
1. Turn the ignition on.
2. Within 4 seconds, press Button 3 to change the setting.
one chirp
=
Passive Arming with chirp
two chirps
=
Active Arming
three chirps =
Passive without chirp
3. Turn the ignition off to save your selection.
Passive Arming
When the Arming Mode has been set for Passive Arming, the system arms itself automatically, each time the ignition is turned
off and all of the doors, hood and trunk are closed.
To start the Passive Arming Process:
1. Turn off the ignition.*
• The status LED will begin to flash quickly.
2. Open the door and exit the vehicle.
• Once all doors are closed and the dome light is turned off, the LED will turn off.
3. After 20 seconds,
• The siren will chirp (if Passive Arming with chirp is selected).
• The parking lights will flash.
• The doors will lock.**
• The status LED will flash red, indicating the system is armed.
4. The system is now armed.
* The ignition must have been on for at least 10 seconds before the Passive Arming sequence will begin.
** If the Passive Locking feature is selected.
To temporarily disable Passive Arming, you can turn the ignition key on then off within 10 seconds. The status LED will stop
flashing, and the system will not passively arm until the next time the key is on for more than 10 seconds. This feature is useful
for turning off passive arming when refueling or washing the car or if you want to sit in your car and do not want the system to arm.
Panic Mode
Allows you to instantly trigger the alarm in an emergency situation using the Remote Transmitter.
To enter Panic Mode:
1. Press and hold Button 1 for 3 seconds.
• The siren will sound.
• The doors will unlock.
2. Press Button 1 again to stop panic and place system into the Armed state.
3. Press Button 2 to stop panic and place system into the Disarmed state.
If Panic Mode is not stopped by the Remote, it will automatically time out after 40 seconds, and the system will return to its
prior Armed/Disarmed state.
Page 7 - G1100 Installation Manual
Advertisement
Table of Contents
