Feature Descriptions; Menu #1 - Basic Features - Clarion SR1000 Installation Manual

Clarion sr1000 cctv systems: installation guide
Hide thumbs Also See for SR1000:
Table of Contents

Advertisement

feature descriptions

The features of the system are described below. Features that have additional settings that can be
selected only when programming with the Pro security programmer are indicated by the following
icon:

menu #1 - basic features

1-1 ACTIVE/PASSIVE ARMING: When active arming is selected, the system will only arm when the
remote is used. When set to passive, the system will arm automatically 30 seconds after the last door
is closed. To alert the consumer of passive arming, the siren will chirp 20 seconds after the door is
closed. This provides the consumer with an audible warning prior to the system actually arming. At
the 30 second mark, the system will arm, but the siren will not chirp.
1-2 CHIRPS ON/OFF: This feature controls the chirps that confirm the arming and disarming of the system.
1-3 IGNITION CONTROLLED DOOR LOCKS ON/OFF: When turned on, the doors will lock three
seconds after the ignition is turned on (with doors closed) and unlock when the ignition is turned off.
There are separate steps for ignition lock and ignition unlock. They can be programmed on or off
independently.
1-4 IGNITION CONTROLLED UNLOCK: When turned ON the doors will unlock when the ignition is
turned OFF.
1-5 ACTIVE/PASSIVE LOCKING: If passive arming is selected in Feature 1-1, then the system can be
programmed to either lock the doors when passive arming occurs, or only lock the doors when the
system is armed via the remote. Active locking means the system will not lock the doors when it pas-
sively arms. Passive locking means that the system will lock the doors when it passively arms.
N N O O T T E E : : Remember, when passive arming is selected, the unit will chirp 20 seconds after the last door is closed.
The system does not actually arm or lock the doors until 30 seconds after the door has been closed.
1-6 PANIC WITH IGNITION ON: This feature controls whether or not the panic mode is available
with the ignition on. In some states, there are laws prohibiting a siren sounding in a moving vehicle.
This feature makes the system compliant with these regulations.
1-7 DOOR LOCK PULSE DURATION: Some European vehicles, such as Mercedes-Benz and Audi,
require longer lock and unlock pulses to operate the vacuum pump. Programming the system to pro-
vide 3.5 second pulses, will accommodate the door lock interface in these vehicles. The default set-
ting is 0.8 second door lock pulses. See (+/-) Door Lock Outputs Harness (H4) section, "Type E -
Mercedes-Benz and Audi -1985 and Newer" diagram.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents