Approvals - Siemens PROFIBUS CP 1542-5 Manual

Approvals

Approvals issued
Note
Issued approvals on the type plate of the device
The specified approvals - with the exception of the certificates for shipbuilding - have only
been obtained when there is a corresponding mark on the product. You can check which of
the following approvals have been granted for your product by the markings on the type
plate. The approvals for shipbuilding are an exception to this.
Certificates for shipbuilding and national approvals
The device certificates for shipbuilding and special national approvals can be found on the
pages of Siemens Automation Customer Support on the Internet
(http://support.automation.siemens.com/WW/news/en/10805878)
Under this entry, go to the required product and select the following settings: "Entry list" tab >
entry type "Certificates".
Standards and test specifications
The device meets the following standards and test specifications. The test criteria for the
module are based on these standards and test specifications.
IEC 61131–2
The SIMATIC NET S7 CPs described in this manual fulfill the requirements and criteria of
the IEC 61131-2 standard (Programmable Logic Controllers, Part 2: equipment requirements
and verifications).
CP 1542-5
Manual, 11/2014, C79000-G8976-C326-03
8
35