Panasonic WJ-HD309 Setup Instructions page 34

Setup Item
I Resolution
Select a resolution for emergency recording from the
following.
FIELD: Standard resolution (720 x 288)
FRAME 3D ON: High resolution (720 x 576) with the
motion blur compensation
FRAME 3D OFF: High resolution (720 x 576)
SIF: Low resolution (360 x 288)
Important:
• It is recommended to set same value for the resolu-
tion of emergency recording as the resolution of
manual recording, event recording and schedule
recording.
• Recording will not be performed for around 4 sec-
onds from the beginning of emergency recording
when the resolution is switched.
I Recording Time
Perform the settings for emergency recording such as
recording time and recording actions.
The following are available for recording time.
1 s - 10 s (in 1 second intervals)
20 s/30 s/1 m - 10 m (in 1 minute intervals)
20 m/30 m/40 m/50 m/60 m
MANUAL: Recording will continue while the external
switch is being held down.
CONTINUE: Recording will not stop unless the [ALARM
RESET] button on the front panel of the unit is
pressed or the [ALARM RESET] button in the status
display area is clicked.
I Recording Rate and Quality
Perform the settings for emergency recording for each
camera channel such as recording rate or image quality.
The following are available for recording rate. When
OFF is selected for a specified camera channel, images
from a camera channel set to OFF will not be recorded.
OFF/1.7 ips/2.5 ips/4.2 ips/5 ips/6.3 ips/8.3 ips/12.5 ips/
25 ips/50 ips/100 ips
34
Important:
• The total recording rates of CAM 1 - CAM 10 must
be less than 50 ips.
• When OFF is selected for a specified camera chan-
nel, images from a camera channel set to OFF will
not be recorded.
• When "FRAME 3D ON" or "FRAME 3D OFF" is
selected, the total recording rates of CAM 1 - CAM
16 (for the WJ-HD316) must be less than 25 ips.
• When "FIELD" is selected, the total recording rates
of CAM 1 - CAM 16 (for the WJ-HD316) must be
less than 50 ips.
• When "SIF" is selected, the total recording rates of
CAM 1 - CAM 16 (for the WJ-HD316) must be less
than 100 ips.
• When "FRAME 3D ON", "FRAME 3D OFF" or "SIF"
is selected, it is impossible to select 50 ips.
The following are available for image quality.
SFA/SFB: Top quality (SUPER FINE)
FQA/FQB: High quality (FINE)
NQA/NQB: Standard quality (NORMAL)
EXA/EXB: Low quality (EXTENDED)
**A is suitable for less dynamic images.
**B is suitable for more dynamic images.
I Auto Copy
Select ON or OFF to set whether or not to automatically
copy images recorded by emergency recording onto the
copy area on the built-in hard disk or DVD-RAM disk.
Important:
When OFF is selected for "Auto copy" on "Basic
setup" of "System", the auto copy function will not
work after emergency recording even though ON is
selected for this setting. Select "HDD", "COPY 1" or
"COPY 2" for the auto copy setup.