Warning settings for available hard disk space [Disk Capacity]
Performing the settings for the warning action should be done when each available space of the built-in hard disk
(normal recording area, event recording area, copy area), an external recording devices such as a DVD-RAM disk,
CD-R disk or DVD-R disk drive connected to the copy port on the rear panel (COPY 1 and COPY 2) reaches the set
level.
Important:
When "CONTINUE" is selected for "Disk End Mode" (page 27), a warning will not be issued.
Screenshot 1
Start operation after the submenu of the maintenance
menu is displayed by clicking the [Maintenance] button
in the [Setup] tab. (page 15)
Screenshot 2
The "Disk Capacity" menu will be displayed.
28
Step 1
Click "Disk Capacity".
Step 2
Perform the settings for the warning action when avail-
able disk space of each area or an external recording
device has run out by clicking the [i] button.
1% to 10% can be set for this item in 1% intervals.
When OFF is selected, the warning action will not be
performed.
Step 3
Click the [SET] button after completing the settings.
Note:
When "CONTINUE" is selected for the recording
area on the "Disk End Mode" menu, the warning
action will not be performed.