Assembling The Trimmer - Stihl FSA 57 Instruction Manual

English
6.3 State of Charge
1
► Press the button (1).
The LEDs (5) glow green for about 5 seconds
and indicate the state of charge.
► If the LED on the right flashes green: Charge
the battery.
6.4 LEDs on Battery
The LEDs can show the state of charge or mal‐
functions. The LEDs can glow or flash green or
red.
The state of charge is indicated when the LEDs
glow or flash green.
► If the LEDs glow or flash red: Troubleshooting,
19.
Malfunction in trimmer or battery.
6.5 LED on Charger
The LED indicates the operating status of the
charger.
If the LED glows green, the battery is being
charged.
► If the LED flashes red: Rectify the malfunction.
Malfunction in charger.
7

Assembling the Trimmer

7.1 Mounting the Deflector
► Switch off the trimmer and remove the battery.
1
2
The line limiting blade (1) is already installed in
the deflector (2) and must not be removed.
► Push the deflector (2) into the guides on the
housing as far as stop.
12
80-100%
60-80%
40-60%
20-40%
0-20%
3
2
The deflector (2) is tight against the housing.
► Insert and tighten down the screws (3) firmly.
The deflector (2) must not be removed again.
7.2 Mounting and Removing the
Mowing Head
7.2.1 Mounting the Mowing Head
► Switch off the trimmer and remove the battery.
1
2
► Fit the fanwheel (2) on the shaft (3) with fan
blades facing down.
If the fanwheel is not fitted, the motor will not
be cooled properly and the trimmer will cut out
during operation.
► Hold fanwheel (2) steady with one hand.
► Fit the mowing head (1) on the shaft (3),turn it
counterclockwise by hand and tighten it down
firmly.
7.2.2 Removing the Mowing Head
► Switch off the trimmer and remove the battery.
► Hold fanwheel (2) steady with one hand.
► Unscrew the mowing head (1) counterclock‐
wise.
► Remove the fanwheel.
7.3 Mounting the Loop Handle
► Switch off the trimmer and remove the battery.
0458-806-0121-B. VA0.M20.
7 Assembling the Trimmer
1
3
1
2
2