Installation Of The Indoor Unit - Daikin FXUQ71AVEB Installation Manual

Drain pan
2.
1.
Projected part
3.
Blocking material
Projected part
Fig. 12
1.
Blocking material
Insert
Projected part
Upper decoration
panel
2.
Lower decoration
panel
Insert the bent part.
(Until you hear a cliking
sound.)
Bent part of
3.
blocking material
Blocking material
Insert
Insert so that the sheet metal
section does not protrude from the
end of the lower decoration panel.
7
Lower decoration panel
Insulation
2.
1.
Upper decoration panel
Insert
Insulation
Lift this part slightly.
(Other side also.)
Lower decoration
panel
Drain pan
Clearance between
lower decoration
panel and drain pan
Fig.13
* If the blocking material is difficult to insert, loosen the left and
right screws of the lower decoration panel and insert it. Make
sure to tighten the loosened screws again after the blocking
material is fixed. (Refer to Fig. 14)
Lower decoration panel
Screw
< Screw location of piping >
Lower decoration panel
Screw
< Screw location other than piping part >
5.

INSTALLATION OF THE INDOOR UNIT

It is easy to attach the optional parts before installing the
indoor unit. Refer to also the installation manual attached
to the optional parts.
For installation, use the attached installation parts and
specified parts.
(1) Attach the upper and lower nuts and the washers for the
hanger (3) to the 4 hanging bolts. (Refer to Fig. 15)
If the attached washer clamp (5) are used, the washer for
the hanger (3) can be prevented from falling off.
(Refer to Fig. 16)
(2) Installation of indoor unit. (Refer to Fig. 17)
• Insert the hangers on the air outlet
them tentatively.
• Insert the remaining 2 hanging bolts into the hanger and
fix the underside washers for the hanger (3) and the nuts.
Screw
Screw
Fig.14
4
side and hang
English