Heatrae Sadia STREAMLINE OVERSINK 95010283 Fitting Instructions And User Manual page 7

3.3 FIXING
1. Mark the position of the Streamline and the position of the fixing bracket
(see figure 2).
2. Fix the wall bracket using the two larger fixing plugs and screws
provided
3. Remove the cover of the Streamline by removing the two screws from the
bottom face and rotating the cover about the top edge.
4. Hang the Streamline on the wall bracket, and mark the position of the
fixing hole (see figure 2)
5. Remove the Streamline from the bracket, drill the third fixing hole, and fit
the third (smallest) fixing plug.
6. Hang the Streamline on the wall bracket again and fix securely with the
third (smallest) fixing screw provided.
3.4 PLUMBING
1. Plumb the Streamline direct to the cold water main using 15mm diameter
copper or plastic pipe. Water pressure should be no lower than 0.034MPa
(0.34bar) and no higher than 1.0MPa (10bar) (see figure 6 overleaf).
2. Fit the flow restrictor (supplied) in the incoming supply (see Figure 6
overleaf).
3. The inlet connection of the Streamline Oversink is an internal 15mm push
fit elbow. Fit the incoming supply pipe through the grommet (snapped to
the back plate) and in to the push fit elbow. Ensure the grommet is re-
seated.
NOTE: It is recommended that a WRAS listed isolating valve (not supplied)
is fitted in the cold water supply to the Streamline for servicing.
FIGURE 05 - FLOW RESTRICTOR
OUTLET
INLET
7