KegLand KL20671 Instruction Manual page 6

Benchy Sparkling - Instruction Manual
Benchtop Dispensing – Shank and Tap Installation
The Benchy Sparkling can be tucked away cleanly under a counter and sparkling and still water
dispensed through taps which are built into your benchtop or it can be displayed and used on the
bench top as a benchtop sparkling and still water dispenser.
To use the Benchy Sparkling as a benchtop dispenser it requires the sparkling water OUT and cold
still water OUT lines to be redirected to shanks and taps inserted into the front of the Benchy
Sparkling.
The following items (sold separately) are suggested to operate the Benchy Sparkling as a bench top
dispenser:
2 x Shanks with 8mm OD duotight fittings
2 x NukaTap Flow Control (KL15523)
2 x Tap Handles (KL01373)
A sharp Stanley knife or a 2 in 1 tube cutter (KL07689) will also be required to shorten the length of
the sparkling water OUT and cold still water OUT tubing.
Shank and Tap Installation
1. Remove the two plastic plugs on the front of the Benchy Sparkling by pinching the raised
clips on the back of the plugs together.
2. Insert the shank into the pre-cut hole.
3. Secure the shank with a 5/8" nut internally and firmly tighten the duotight fitting onto the
short shank thread.
4. Tighten the shank collar onto your tap firmly with a 7 in 1 tool (KL07672).
Page 6 of 12
www.KegLand.com.au Last Updated 20/07/2021 10:11 AM