Package Contents - Stanley SL207 Manual

ENGLISH
(Original instructions)
LABELS ON TOOL
The label on your tool may include the following symbols:
WARNING! To reduce the risk of injury, the user
must read the instruction manual before use.
Wear safety glasses or goggles.
Wear ear protection.
Wear a dust mask.
V Volts
A Amperes
Hz Hertz
W Watts
min minutes
Alternating
Current
Position of date code
The date code, which also includes the year of manufacture,
is printed into the housing.
Example:
2017 XX JN
Year of manufacturing

PACKAGE CONTENTS

1 Angle grinder
1 Guard
1 Side handle
1 Flange set
1 Two-pin spanner
1 Instruction manual
• Check for damage to the tool, parts or accessories which
may have occurred during transport.
• Take the time to thoroughly read and understand this
manual prior to operation.
FEATURES (Fig A)
This appliance includes some or all of the following features.
WARNING: Never modify the power tool or any part
of it. Damage or personal injury could result.
1. Switch
2. Spindle lock
3. Guard
4. Side handle
8
Direct Current
n No-Load Speed
0
Class II Construction
Earthing Terminal
Safety Alert Symbol
Revolutions or
/min. Reciprocation per
minute
Purpose of design
This angle grinder is designed especially for grinding.
Do not use sandpaper discs and grinding wheels other than
those with depressed center.
Do not use the tool in wet conditions or environments in the
presence of flammable liquids or gases.
This angle grinder is a professional power tool.
Do not allow children to come in contact with this tool.
Inexperienced operators are required to use this tool under
supervision.
ASSEMBLY
WARNING: To minimize the danger of serious
personal injury, please switch off the tool power
and disconnect all plugs before adjusting or
removing/installing any accessory. Before
reassembling the tool, press and release the trigger
switch to make sure the tool is already switched off.
Attaching and removing the wheel guard (Fig. B)
WARNING To minimize the danger of serious
personal injury, please switch off the tool power
and disconnect all plugs before adjusting or
removing/installing any accessory. Before
reassembling the tool, press and release the trigger
switch to make sure the tool is already switched off.
Attaching the guard
1. Place the angle grinder on a work bench, groove facing
up.
2. Bring the flange of the guard (3) collar over the groove of
the gear housing.
3. Turn the guard (3) counterclockwise by 150 degrees.
4. Make sure that the screws (12) are tightened.
Removing the guard
1. Loosen the screws (12) on the guard collar.
2. Pull up the guard (3).
WARNING: Do not operate the tool when the safety
guard is not in place.
Fitting and removing a grinding wheel (Fig C1, C2, C3)
WARNING: Do not use damaged grinding wheels.
1. Place the tool on a work bench, guard up.
2. Fit the inner flange (5) correctly onto the spindle (6)
(Fig. C1).
3. Place the disc (7) on the flange (5) (Fig.C2). When fitting a
disc with a raised center, make sure that the raised centre
(8) is facing the flange (5).
4. Screw the out flange (9) onto the spindle (6) (Fig. C3)
- the ring on the flange (9) must face towards the disc
when fitting a grinding disc (C3-A)
- the ring on the flange (9) must face away from the
disc when fitting a cutting disc (C3-B)