Package Contents - Stanley STGS7100 Original Instructions Manual

Cable cross-sectional
area (mm 2 )
0.75
1.00
1.50
2.50
4.00
Voltage Amperes
110-127 0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
220-240 0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
LABELS ON TOOL
The label on your tool may include the following symbols:
WARNING! To reduce the risk of injury, the user
must read the instruction manual before use.
Wear safety glasses or goggles.
Wear ear protection.
V Volts
A Amperes
Hz Hertz
W Watts
min minutes
Alternating
/min.
Current
Cable rated current
(Ampere)
6
10
15
20
25
Cable length (m)
7.5 15 25 30 45
Cable rated current (Ampere)
6 6 6 6 6
6 6 6 6 15
6 6 10 15 20
10 10 15 20 20
15 15 20 25 25
20 20 25 - -
6 6 6 6 6
6 6 6 6 6
6 6 6 6 10
10 10 10 10 15
15 15 15 15 20
20 20 20 20 25
Direct Current
n No-Load Speed
0
Class II Construction
Earthing Terminal
Safety Alert Symbol
Revolutions or
Reciprocation per
minute
Position of date code
The Date Code, which also includes the year of manufacture,
is printed into the housing.
Example:

PACKAGE CONTENTS

The package contains:
1 Angle Grinder
1 Guard
1 Flange set
60
1 Spanner
1 Handle
1 Instruction Manual
10
• Check for damage to the tool, parts or accessories which
may have occurred during transport.
15
• Take the time to thoroughly read and understand this
20
manual prior to operation.
FATURES (Fig A)
25
This tool includes some or all of the following features.
-
1. ON/OFF Switch
-
2. Spindle Lock
6 3. Guard
11. Side Handle
6
ASSEMBLY
15
WARNING! To prevent accidental operation, turn off
15
and unplug tool before performing the following
operations. Failure to do this could result in serious
20
personal injury.
-
Attaching and removing the wheel guard (Fig B)
WARNING! To minimize the danger of serious
personal injury, please switch off the tool power and
disconnect all plugs before adjusting or
removing/installing any accessory. Before reassembling the
tool, press and release the trigger switch to make sure the tool
is already switched off.
Attaching the guard
1. Place the angle grinder on a work bench, groove facing
up.
2. Bring the flange of the guard (3) collar over the groove (9)
of the gear housing.
3. Turn the guard (3) counterclockwise by 150 degrees.
4. Make sure that the screws (10) are tightened.
Removing the guard
1. Loosen the screws (10) on the guard collar.
2. Pull up the guard (3).
WARNING! Do not operate the tool when the safety
guard is not in place.
NOTE: Refer to the grinding and cutting accessories chart at
the end of this section for accessories that can be used
together with this angle grinder.
(Original instructions)
2017 XX JN
Year of manufacturing
ENGLISH
7