Jumper Settings; Pal/Ntsc Video Output Select (Jp1, Jp2, Jp4) - Advantech PCM-3524 User Manual

2.2 Jumper Settings

Making the proper jumper settings to configure the PCM-3524 to match
the needs of your application.
Table 2.1: Jumpers
JUMPER
JP1
JP2
JP3
JP4
JP5
JP6
JP7
JP8
JP9
JP10
JP11
JP12
JP14

2.2.1 PAL/NTSC Video Output Select (JP1, JP2, JP4):

Timing, sub-carrier frequency, and phase parameters are preprogrammed
into the module and correspond to worldwide NTSC and PAL standards.
Use TD0 and TD1 to select one of four sets of parameters to set up the
encoder. The frame rate of the graphics source must be twice the frame
rate of the selected video standard. Please see Table 2.2
Table 2.2: Output Mode Settings
NTSC
NTSC-EIA
PAL-BDGHI
PAL-N
PAL-Comb-N
PAL-M
NAME
TD0
TD1
RESERVED
PAL_NTSC
PWRDN
RGB_OUT
RESERVED
YUV_OUT
RESERVED
RESERVED
RESERVED
RESERVED
POWER Selection
JP4
Short
Short
Open
Open
Open
Short
7
Default
Short
Short
Open
Short
Short
Short
Open
Short
Open
Open
Open
Open
Short 2-3
JP2 JP1
Short Short
Short Open
Short Open
Short Short
Open Open
Open Short
Chapter 2 Installation