Cisco Firepower Management Center 1600 Getting Started Manual page 22

Connect Cables Turn On Power Verify Status for Versions 6.3 - 6.4
Connect Cables Turn On Power Verify Status for Versions 6.3 - 6.4
This procedure references the rear panel ports of the FMC 1600, 2600, and 4600.
AC power supplies have internal grounding so no additional chassis grounding is required when the supported
AC power cords are used. For more information about supported power cords, see the
Management Center 1600, 2600, and 4600 Hardware Intallation
We recommend that you establish a connection to support alternate access to the FMC for troubleshooting in
case of network outage or other problems that prevent you from accessing the FMC web interface. You can
establish one or more of the three connections listed below; console messages will appear in the output you
select in the FMC web interface under System > Configuration > Console Configuration.
• Connect a keyboard and monitor to the FMC as described in steps 5 and 6. (The FMC sends console
• Connect a local computer to the FMC serial port as described in Step 7. (To use this connection see
Cisco Firepower Management Center 1600, 2600, and 4600 Getting Started Guide
22
Pre-Configuration Review Network Deployment for Versions 6.3-6.4, on page 19
Pre-Configuration Connect Cables Turn On Power Verify Status for Versions 6.3 - 6.4, on page
22
Firepower (Optional) Configure Network Settings Using a Physical Connection for Software
Management Center Versions 6.3 - 6.4, on page 25
Firepower FMC Initial Setup Using the Web Interface for Software Versions 6.3 - 6.4, on
Management Center page 25
Firepower Configure FMC Administrative Settings, on page 29
Management Center
Firepower Add Managed Devices to the FMC, on page 38
Management Center
messages to the VGA port by default.)
Up Serial Access, on page 39.)
Cisco Firepower Management Center 1600, 2600, and 4600 Getting Started Guide
Guide.
Cisco Firepower
Set