Cisco Firepower Management Center 1600 Getting Started Manual page 46

Preconfigure Time Management
• The time zone (if you choose to manually set the time for your appliances)
• The remote storage location for automatic backups
• The LOM IP address to enable LOM
Preconfigure Time Management
Procedure
Step 1
Synchronize time to a physical NTP server.
Step 2 Set the IP addresses for the DNS and NTP servers using one of the following methods:
• If your network at the staging location can access the DNS and NTP servers at the target location, use
• If your network at the staging location cannot access the DNS and NTP servers at the target location,
Step 3
Use the time zone for the target deployment if you set the time on the appliance manually instead of using
NTP. For more information, see the
Install the System
Procedure
Step 1 Use the installation procedures appropriate for your version:
• For Firepower Versions 6.5 and later, see
• For Firepower Versions 6.3 - 6.4 see
Step 2
For more information on installing the chassis, see the
4600 Hardware Installation
Prepare a Firepower Management Center for Shipment
Procedure
Step 1 Safely power down the FMC. For more information, see the
and 4600 Hardware Installation
Step 2 Ensure that your appliance is safely prepared for shipping. For more information, see
on page
Cisco Firepower Management Center 1600, 2600, and 4600 Getting Started Guide
46
the IP addresses for the DNS and NTP servers at the target location.
use the staging location information and reset at the target location.
Guide.
Guide.
47.
Cisco Firepower Management Center 1600, 2600, and 4600 Getting Started Guide
Firepower Management Center Configuration Guide
Install the FMC for Versions 6.5 and Later, on page 6
Install the FMC for Software Versions 6.3 - 6.4, on page
Cisco Firepower Management Center 1600, 2600, and
Cisco Firepower Management Center 1600, 2600,
for your version.
19.
Shipping Considerations,