Cisco Firepower Management Center 1600 Getting Started Manual page 44

Use the Shell to Redirect the Console Output
Before you begin
Complete the initial setup process appropriate to your Firepower version:
• For Firepower Versions 6.5 and later see
• For Firepower Versions 6.3 - 6.4 see
• Disable Spanning Tree Protocol (STP) on any third-party switching equipment connected to the device's
Procedure
Step 1
Choose System > Configuration.
Step 2 Choose Console Configuration.
Step 3
Select a remote console access option:
• Choose VGA to use the appliance's VGA port. (This is the default.)
• Choose Physical Serial Port to use the appliance's serial port.
Step 4
Click Save.
Use the Shell to Redirect the Console Output
Before you begin
Complete the initial setup process appropriate to your Firepower version:
• For Firepower Versions 6.5 and later see
• For Firepower Versions 6.3 - 6.4 see
Procedure
Step 1 Use the FMC CLI admin credentials to access the Linux shell on the FMC using the method apppropriate to
your Firepower version; see
Step 2
At the prompt, set the console output by entering one of the following commands:
• To direct console messages to the VGA port:
• To direct console messages to the physical serial port:
Step 3
To implement your changes, reboot the appliance by entering
Cisco Firepower Management Center 1600, 2600, and 4600 Getting Started Guide
44
management interface.
Access the CLI or the Linux Shell on the FMC, on page
serial
Cisco Firepower Management Center 1600, 2600, and 4600 Getting Started Guide
Install the FMC for Versions 6.5 and Later, on page
Install the FMC for Software Versions 6.3 - 6.4, on page
Install the FMC for Versions 6.5 and Later, on page
Install the FMC for Software Versions 6.3 - 6.4, on page
sudo /usr/local/sf/bin/configure_console.sh vga
sudo /usr/local/sf/bin/configure_console.sh
sudo reboot
6.
19.
6.
19.
5.
.